Big Mouth, Wide Mouth Downspout Outlet for clog free gutters

Simple 'no template' instructions:

Here is a simple way without a 'template'

Place WideMouth at installation location. (Sliding the tall back into place will help to keep it in position )

Mark left and right with a light pencil mark.

Keep in mind you will need to move the left and right lines closer to each other as your pencil lines INCLUDE the width of the 'stabilizing wings'.

Measure the width of the 'wings' plus .5" - so your left and right cut lines are now closer together.

As for the left and right - the width - We like to see that opening about 1" smaller than inside measurement of the Wide Mouth. If you cut the gutter tray too far back the water will leak out a bit - So better to make that opening a bit smaller opening in the gutter tray so water stays inside the gutter and flows into the WideMouth

=======================

Allow the water in the gutter to drain faster and keep your gutters clog free with a drain outlet that is many times larger then the typical gutter drop outlet. This gutter to downspout water funnel outlet should be installed with pop-rivets instead of screws for cleaner look. The back slips up the backside of the gutter tray next to the house and stabilized with a screw or two . There will be NO raised lip inside of the gutter's bottom to restrict the water or debris from entering the downspout. A very low tech idea that solves 2 very important issues - residual water in the gutter and debris that gets caught on the raised lip of the traditional drop outlet.

You paid good money to have those gutters installed and most of the time they are holding back water and debris. Increase the volume of water and the amount of debris that leave what your gutters with this wide mouth downspout outlet funnel.

A long time ago we found a product very similar to this one. It's made of plastic. If you were not very careful when you installed it, they cracked.



Big Mouth, Wide Mouth Downspout Outlet made from .027 low gloss white aluminum

Two sizes to choose from:

5" K gutter for use with 3x4 downspout - Approximately 8" wide (including tabs) x 3.25inches
6" K gutter for use with 3x4 downspouts

5" K gutter for use with 2x3 downspout

Made from .027 aluminum
Low gloss white is stock - 25 piece minimum order for custom color run
Can be primed and painted.